ELASTIC CEMENTITIOUS TILE ADHESIVE WITH FIBRES, CLASS C2TE S1 In compliance with the requirements of Standard ЕN 12004
Portland cement, fractionated quartz sand, polymer additives, fibers.
High quality elastic construction adhesive for outdoor and indoor application, for thinbed applying on ceramic tiles, natural stones and Granitogres, for adhesion in cases of increased load, over underfloor heating, and hydro insulated floors. Suitable for vertical and horizontal substrates and large tiles.
Improved strength, increased open time, decreased slipping when laid on vertical substrates, water- and cold resistant.
PREPARATION OF THE SUBSTRATE
The substrate must be clean, dry and sound, without cracks. Primer must be applied beforehand on highly absorbent surfaces.
PREPARATION OF THE MIXTURE
Mix a bag of 25 kg of adhesive with 5.5 L of water. In a suitable container add the dry mix to the required quantity of water and mix with a mixing device until a homogeneous consistency is attained. Leave the mixture to stay for 10 min., then mix again and the product is ready to use. Important – re-stirring the mixture increases the strength indices of the product.
Apply the adhesive with a square notch trowel with notch size from 4 x 4 mm to 8 x 8 mm depending on the size of the tile. First apply a thin contact layer on the substrate and then using the notched side of the trowel, comb out the still fresh adhesive. Lay and press the tiles in the fresh adhesive. When laying non-porous tiles, tiles with large sizes, or laying tile on tile, apply adhesive on the substrate and on the back of the tile –this will guarantee maximum adhesion between the tile and the adhesive.
Addition of other materials in the ready mixture is not allowed. The recommended temperature range of use is from +5°C to + 35°C.
From 2 kg/m2 to 5 kg/m2 depending on the size of the notches of the square trowel and how even the surface is.
To be kept in a dry and well ventilated place.